Versions Compared

Old Version 5

changes.mady.by.user Doug Daniels

Saved on

compared with

New Version Current

changes.mady.by.user Doug Daniels

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Note: per the advice from medical professionals, please try to limit the number of persons that handle these prints as much as possible, both throughout the printing process and the delivery.

Image Removed

Image Removed

Image Added


Estimates from UCLA Health for the number of masks that will be required range from thousands to over 25,000. As such, any and all help is greatly appreciated.

Please contact dougdaniels@library.ucla.edu if you have any questions.

               

Image Added

Please note that as of this writing, 3/21, there are two versions of the face shield. Both versions are viable, however RC2 is preferred

Prusa - face mask

Headband V1.stl - smaller, designed to maximize production.

Headband V2.stl - larger, designed for comfort rather than mass production

Bottom reinforcement.stl



These are the settings that were most preferred. We also did tests using Prusa's recommended settings, which also work.


Layer HeightInfillShellsSupports
0.3mm0%10Disabled




Because both versions are viable, and because we are in need of such a large quantity, please try to maximize your build plates as much as possible. So if you're like me and can only fit one V2 headband on a build plate at a time, but could also squeeze in a V1 print alongside, please do so!

              


When a batch of prints is ready to be delivered, it will need to be taken to Powell Library.